How To Open An Inground Pool With A De Filter

With water to form a wet sludge, and then pour the solution directly into the skimmer. Tips on using a de filter.

HAYWARD Aboveground Swimming Pool DE Filter System w/1 HP

Open the vent valve and the filter drain (if the filter is below the water level you will need to close suction and return valves) allow all water and dirt to drain out completely.

How to open an inground pool with a de filter. If youre using a solid cover, drain the water off the cover using a submersible pump. You may want to add extra water to the pool because when youre vacuuming the pool for the first time, its best to vacuum it with the diverter handle in the waste position so the debris is discharged without sending it through the filter. Follow these steps to properly winterize your d.e.

Don't forget to install the diving board properly. Reinstall the clamp band, tightening until all spring sides touch each other. As soon as backwashing is complete, add the appropriate amount of de to the skimmer so it will coat the filter grids.

Make sure to remove water on top of the cover, any debris, and tubing securing the cover. If your water level is low fill it to the proper level which is between the two middle screws on the skimmer or half way up the skimmer. Steps to backwash a de or sand filter system.

Below are the steps for opening your inground pool. Open the drain plug located on the bottom of the filter allowing the water inside the tank to be drained out. Some pool filters may have bolts instead of clamps.

If an above ground pool, the excess water may be siphoned off instead. Once completely drained and with the drain open, run the pump for a few seconds. If not, add more water to the pool.

Of filter surface area (which is printed on the filter label). The powder will travel through the plumbing and effectively recharge the filter. That is your clean filter pressure.

Filter, youll need to replace the powder, which is much more effective to do through the pools skimmer. Pump off any excess rain water with a submersible pump. A couple of minutes after you add de, note the filter pressure.

To do this, you want to mix the manufacturers recommended amount of d.e. Remove any leaves and debris from the winter pool cover. Open all valves, open air bleeder, then restart filter pump, watching for a gauge spike.

Add de powder to the filter to replace the amount that was backwashed out. Check the skimmer, filter, and pump before allowing anyone in. Try to minimize the amount of water and/or debris that gets into the pool water.

Turn off and unplug the pool pump. Remember to check the manual to help you with the settings on when to backwash. This is called the belly band.

Add de powder through the skimmer, at a rate of 1lb per 5 sq. Uncover the skimmer closest to the pump and filter, and slowly pour the needed amount into the skimmer while the system is running. The biggest things you need to remember is adding de to the filter after you backwash.

Remove the leaves and debris from the pool cover with a leaf net and/or skimmer net. Pool filter system at seasons end: Remove water and debris from your pool cover.

The removal of mesh or solid safety cover, fold and bag the cover, then put it where you want it stored for the summer. Check the skimmer opening and make sure that the water in the pool is at least halfway up the opening. De filters are honestly pretty easy to use when you get the hang of it.

Most de filters should use a 1 lb (32 oz dry measure) of de powder for every 5 sq. Turn off pool equipment at the main power switch. As soon as you have the pump running and set to filter you should add de.

There is no need to backwash until the filter pressure goes up about 6 psi above the clean pressure. Remove the clamp holding the top of the tank to the bottom of the tank. When you backwash your d.e.

Open your in ground pool and get it ready for summer. Clean the cover thoroughly and let it dry in the sun before storing it.

Swimming pools above ground covers Ground Check more at